Hello,
i try to create an axis with type Through an Edge. I try to position the new axis on a specific edge from a surface by set the "PRO_E_DTMAXIS_CONSTR_REF" field.
But it is only possible, to use the whole surface as reference, and ProE takes always the first edge of surface to create an axis.
How can i specify, which edge on surface i take for axis creation?
If somebody have some experience in this area would be nice.
best regards
Ilja
Edited by: emAG
i try to create an axis with type Through an Edge. I try to position the new axis on a specific edge from a surface by set the "PRO_E_DTMAXIS_CONSTR_REF" field.
But it is only possible, to use the whole surface as reference, and ProE takes always the first edge of surface to create an axis.
How can i specify, which edge on surface i take for axis creation?
If somebody have some experience in this area would be nice.
best regards
Ilja
Edited by: emAG