Create chamfer between two points

[KrisR]

View attachment 5553


I need to create a cham between the two blue lines that you see on the above image. How would one go about this in ProE? Thank you in advance.

 

[Bob_W]

Kris:

The easiest for me, using WF4 would be to use a Variable Section Sweep.

Bob

 

[KrisR]

Thank you Bob. One of the folks here at work assisted me. That's what we did.

 

[dross]

I don't see any Blue lines.

 

[bfairhurst]

you could place a point where each blure line is located, create a edge chamfer, select the edge, select switch to transition mode in the dash board, select the transition tab, select one of the points as a reference, add another transition set and select the next point as a reference. This works in wf4.