Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.
I,d start witha 360 degrotatedextrusion with the "shaft" and "lobes" at the correct dia and placement. Then I,d extrude (cut) away the unwanted surfaces. That would be easest for me anyway.
I am not an automobile engineer... However I would assume that the cams are used to close and open the valves of an engine. It would also be dependent on time. i.e in time t of total time T, how much the valve has opened.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
