Bill of materials

[REALJOHNFROST]

Somebody could tell me if with PROE is possible make a Bill of Materials with the units and measures of ourpart of the assemblie?. How?


Thank you

 

[Tobyk]

Using a repeat region I was able to extract the mass units for individual assembly parts in a Bill of Materials.

See this post:

http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=35 100&KW=ptc+unit

I haven't tried it for other units of measure but using the same method should work.

Note this was done in Wildfire 3.

Hope this helps.

Tobyk

 

[design-engine]

if the variable is not available to you by default you can always create your custom setting with a parameter. thru a relation you can create any math you want converting from cubic inches to volume ounces etc...