Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.
Does anyone do renderings in Creo 2.0?
Specifically, transparent parts?
My recent experience has been that Creo 2.0 does a rather poor job rendering transparent appearances. Much worse than Wildfire. Like really, really bad. Anyone?
I only did some test, Creo uses Mental Ray rendering engine and if set up properly results are extremely good. I'd rather invest in a specific tool like Keyshot if I was going to do lots of rendering though
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.