angle difference between planes

[kashinsj]

Hello all. I am trying to dimension the angle difference
between two planes where they would be parallel if both are
flat. One of the top plane is slightly tilted while the
bottom plane is horizontal. I want to show the angle of
that tilt. Is there a way to do so?

 

[dakeb1]

Not sure exactly what you are trying to do, but often inCADif you need to dimension very small angles you need to increase the angle, create the dimension, then modify it back to what you want, or else ProE may assume you are creating a linear dimenions

 

[dr_gallup]

Minimum_angle_dimension Set it to a smaller value than the angle you are trying to dimension.