Results 1 to 4 of 4
  1. #1

    Creo won't regenerate fully

    I have an annoying problem that I'm hoping someone knows how to solve...

    While working with models with either a skeleton, copy geom or both, I get a second regeneration after a feature is completed. However, the second regen wont happen until I click on the screen or rotate the model. When I click the screen or rotate the model...it goes back into another regen...sometimes briefly and sometimes not depending on how far down the model tree I am. This is ultimately costing me quite a bit of time. Do you know what could be causing this? Is it a config setting? I have auto-regen turned off permanently and making the skeleton read-only doesn't make a difference.

    Thanks in advance.

  2. #2
    can you upload the model?
    Bart Brejcha
    DESIGN-ENGINE|EDUCATION

    http://www.proetools.com Creo Training

  3. #3
    Quote Originally Posted by design-engine View Post
    can you upload the model?
    Hey Bart...been a while, hope you're doing well buddy.

    Unfortunately I can't upload the model as it's proprietary and a huge cylinder block model.

  4. #4
    I've never seen a situation where the second regeneration happens upon manipulating the model.

    Does the model have any circular references?
    David R. Martin II
    MCAE Consulting, LLC
    www.creowindchill.com
    dmartin@creowindchill.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •