Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Flattening a harness in Creo across a splice

Zrider

New member
I've an issue in Creo when flattening a harness. Two 6 gauge wires route to this splice from one direction with one wire stopping at the splice and the other continuing to a second splice. There are two separate bundles/looms on either side of the affected splice. The harness routes clean in the model, but when flattening, the harness routes fine to this splice, but shifts/offsets to one side of the splice after. Is there anyway to correct this? Hopefully I've described the issue well enough.
 
the splice is a solid model assembled into the routed harness on a network point using 'insert component' and using the splice's 'entry_1' csys.

The pic is the flattened harness where the error occurs.

problems.JPG
 

Sponsor

Articles From 3DCAD World

Back
Top