Thru hole without the THRU annotation
Is there a way for CREO to not display the word THRU in the callout when I have a thru hole?
08-23-2016, 01:55 PM
You will need to create a custom note since, by default the hole notes call up the depth of the hole & the thread if using the hole tables - however if you don't use the hole table, you don't get a hole note unless you specifically create a setup note attached to the hole.
08-24-2016, 06:53 AM
I found from the ptcusercommunity that I can customize the hole table more than I thought possible.
08-24-2016, 02:26 PM
I never use the notes that Creo provides.
They are too long and contain unesecessary information.