Results 1 to 5 of 5
  1. #1

    Edge display problem in assembly drawing

    Hello!

    I have this problem that's been bugging me for a while. Sometimes when I create a drawing the edges of the part or assembly comes out wrong.

    For example, the bottom plate of this weld asm has two holes that the keys go into, but both of them are shown wrong.
    Click image for larger version. 

Name:	Capture.JPG 
Views:	33 
Size:	94.2 KB 
ID:	6849

    This is how it's supposed to look:
    Click image for larger version. 

Name:	Capture2.JPG 
Views:	26 
Size:	68.8 KB 
ID:	6850

    Any suggestions would be much appreciated!

  2. #2
    Is there any interference between the 2 features? I have seen this happen when 2 features overlap.
    Krow72
    ____________________________
    WF4 / Croe 2

  3. #3
    This will usually occur when the parts actually have interference with each other.
    Scott

  4. #4
    I've been on vacation, sorry for the late answer.

    The parts have small interference zones, so it seems you were spot on.

    Thanks for the help!

  5. #5
    That was a long vacation...lucky you :-). Glad we could help you out.
    Krow72
    ____________________________
    WF4 / Croe 2

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •