JohnKrasnic
New member
Hi,
I want to show a symbol on a drawing that depends on the parameter. The symbols are loaded in the drawing and named "company1", "company2" and "company3".
I have a parameter named par_comp that I want to use to show the correct symbol.
But if I have a note with "&sym(&par_comp)" it doesn't work. It just shows &sym(&par_comp)
However if my note says "&sym(company1)" it works and shows my logo.
Is there a way to drive that by the parameters?
Thank you very much,
John
I want to show a symbol on a drawing that depends on the parameter. The symbols are loaded in the drawing and named "company1", "company2" and "company3".
I have a parameter named par_comp that I want to use to show the correct symbol.
But if I have a note with "&sym(&par_comp)" it doesn't work. It just shows &sym(&par_comp)
However if my note says "&sym(company1)" it works and shows my logo.
Is there a way to drive that by the parameters?
Thank you very much,
John