Results 1 to 2 of 2
  1. #1

    Question Flow Simulation : air around an rotating cylinder

    Im a student in High school and im working on a project of an aeromodelism aircraft lifted by wings working with the Magnus effect : Cylinder wings rotating around themselves, the Magnus effect would product a lift (see :
    Ive decided to highlight the Magnus effect and to deduct a difference of pressure that will be used to establish the lift effort using Solidworks Flow Simulation.
    After many tries, impossible to obtain a good result.To begin, ive just represented the wing as a cylinder to simplify the calculations as far as I could. Then, I followed this method :, which consists to simulate the pieces rotation by a cylinder which contains it.
    First, I met the following issue : impossible to do the calculations with the software, the piece in rotation was the same as the cylinder created in order to simulate the rotation. An error was popping up to the screen without any results.
    By modifying the diameter of the piece, I could obtain results but they were unlikely.

    Thats why I am turning towards you, I hope I had been clear enough, if you need any other informations, ask me.
    Thank you for your help.

  2. #2

    Flow Simulation air around an rotating cylinder


    Im undecided on this one yet.
    Would you like to protect one specific flow with a password or all flows?


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts