Hello,
I have been using Pro-E Creo 1.0 Expert Machinist for about 6 months or so. When I was shown how to use the software, I was told that using Volume Rough was the best way to finish, and that it gave you the most control over the tool paths.
I could not find any real help online as far as NC programming for Creo and would appreciate any help or advice.
I have not had any luck figuring out corner slow down, re-roughing, or finishing. As I said, I use Volume Rough for most finishing.
This may sound like silly questions, but this software is good at making me feel silly.
Thanks for your time and help, Dave
I have been using Pro-E Creo 1.0 Expert Machinist for about 6 months or so. When I was shown how to use the software, I was told that using Volume Rough was the best way to finish, and that it gave you the most control over the tool paths.
I could not find any real help online as far as NC programming for Creo and would appreciate any help or advice.
I have not had any luck figuring out corner slow down, re-roughing, or finishing. As I said, I use Volume Rough for most finishing.
This may sound like silly questions, but this software is good at making me feel silly.
Thanks for your time and help, Dave