Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Please help with corner slow down, re-roughing, and finishing.

DVF13

New member
Hello,
I have been using Pro-E Creo 1.0 Expert Machinist for about 6 months or so. When I was shown how to use the software, I was told that using Volume Rough was the best way to finish, and that it gave you the most control over the tool paths.
I could not find any real help online as far as NC programming for Creo and would appreciate any help or advice.
I have not had any luck figuring out corner slow down, re-roughing, or finishing. As I said, I use Volume Rough for most finishing.
This may sound like silly questions, but this software is good at making me feel silly. :confused:
Thanks for your time and help, Dave
 

Sponsor

Articles From 3DCAD World

Back
Top