Charis Demetriou
New member
hello everyone,
I am designing a normal cng car tank.. i am doing mechanica analysis but i am sure i have mistakes on my constrains. I cut my model in the half and I put the constraints fixed to all axis at the surface that was cutted but this is wrong. When I tried to let free X and Y axis there was not going through analysis since diagnostics say there are not enough constraints. Where should I put them and what type of constrains i should use?
I am designing a normal cng car tank.. i am doing mechanica analysis but i am sure i have mistakes on my constrains. I cut my model in the half and I put the constraints fixed to all axis at the surface that was cutted but this is wrong. When I tried to let free X and Y axis there was not going through analysis since diagnostics say there are not enough constraints. Where should I put them and what type of constrains i should use?
Last edited: