eolceroglu
New member
hello everyone,
i cannot draw a tangent/tangent/radius arc in sketcher. in modeling
part it is easy. there is curves toolbar and you can find everything
you need there. but they are not defined in sketching i think because
you cannot assign them as boundaries while trimming.So how can i draw a
tangent/tangent/radius arc in SKETCHER?(i tried circle or arc by 3
points but still i cannot do it)
Edited by: eolceroglu
i cannot draw a tangent/tangent/radius arc in sketcher. in modeling
part it is easy. there is curves toolbar and you can find everything
you need there. but they are not defined in sketching i think because
you cannot assign them as boundaries while trimming.So how can i draw a
tangent/tangent/radius arc in SKETCHER?(i tried circle or arc by 3
points but still i cannot do it)
Edited by: eolceroglu