Barbarpapa1
New member
Hello dear Unigraphics experts
I'm new in Unigraphisc modeling (I'm recently using NX2), so I did one stupid thing while making my first models. I was using Inch units sistem instead of metric. So is there some any way how to convert such parts from Inch system to metric (mm) interpreting sketch dimensions (All parts are fully parametric). I mean that the sketch dimensions should remain as they allready are only notto represent inches but mm instead (as result parts should be 25.4 times smaller as they are now).
Thank You
Joze Barbaric
I'm new in Unigraphisc modeling (I'm recently using NX2), so I did one stupid thing while making my first models. I was using Inch units sistem instead of metric. So is there some any way how to convert such parts from Inch system to metric (mm) interpreting sketch dimensions (All parts are fully parametric). I mean that the sketch dimensions should remain as they allready are only notto represent inches but mm instead (as result parts should be 25.4 times smaller as they are now).
Thank You
Joze Barbaric