Hello,
I was wondering if it is possible to create a copy of an (imported) design surface or quilt in its original or maximum size without cut contours. Let me try to explain:
The image below shows part of an imported 3D quilt that has a cut running throug it. Before the cut was made, the surfaces in yellow were 1 single surface, as were the surfaces in pink.
So these surfaces must have the same mathematical definition. Is it possible to create an extended copy or just simply extend one of the sufaces to its original uncut size or to its maximum size mathematically possible?
Good old I-DEAS could do this and it was a great function to repair and clean imported surfaces data!
View attachment 5396
Thank you for any help.
I was wondering if it is possible to create a copy of an (imported) design surface or quilt in its original or maximum size without cut contours. Let me try to explain:
The image below shows part of an imported 3D quilt that has a cut running throug it. Before the cut was made, the surfaces in yellow were 1 single surface, as were the surfaces in pink.
So these surfaces must have the same mathematical definition. Is it possible to create an extended copy or just simply extend one of the sufaces to its original uncut size or to its maximum size mathematically possible?
Good old I-DEAS could do this and it was a great function to repair and clean imported surfaces data!
View attachment 5396
Thank you for any help.