Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

extrude solid/ surface

kenppy

New member
The number of times that I hit extrude make the section and then realize that I didn't pick surface, then figure do I close this and start again or go back to sketcher and close the section then pick surface, then resketch....

Is there a config option that would make the default extrude section a surface by default.

Just asking.
 
I believe that in wf1 , when you left the section open, it was automatically a surface.... but that option was later removed. Doesnt help you thoo...


Mapkey as mentioned above is a nice way.


//Tobias
 

Sponsor

Articles From 3DCAD World

Back
Top