Concentric hole

[dross]

Just switched over to WF4 M140. When using the hole function, a coaxial or concentric hole is not available, where'd it go?


Linear, radial and diameter are the only choices.

 

[bfairhurst]

It has to do with the order you pick your references. If you pick lets say the axis first you will see coaxial light up.

 

[dross]

I tired that, it works. Thanks!


I notice that if you do it that way, then the other options are greyed out.

 

[kdem]

The reference selection has changed in that you no longer go toa secondary reference collector. For a coaxial hole both references are selected in the Placement collector. Select one reference and CTRL+second reference.

 

[dross]

I wish PTC would tell us about these differences. It is not noted in the document covering the changes from WF3 to 4.