Hey Folks!
I am almost done with my first conceptual model of my plane! I am so excited! I figured out how to generate wings with the correct sweep, twist, and airfoils and import the curves in an IBL file (WF 4.0). I used the boundary blend tool with much success to generate the wing surfaces using curves of 1 direction (The airfoil sections). What I can't figure out how to do is use the airfoil sections at the root and tip to cap off the blend and make a solid out of each wing. How should I accomplish this? Each airfoil section is 1 curve starting at the trailing edge and ending at the trailing edge... Below shows the holes I am trying to fill. Can anyone help me? Thanks!
-Chris Z.
I am almost done with my first conceptual model of my plane! I am so excited! I figured out how to generate wings with the correct sweep, twist, and airfoils and import the curves in an IBL file (WF 4.0). I used the boundary blend tool with much success to generate the wing surfaces using curves of 1 direction (The airfoil sections). What I can't figure out how to do is use the airfoil sections at the root and tip to cap off the blend and make a solid out of each wing. How should I accomplish this? Each airfoil section is 1 curve starting at the trailing edge and ending at the trailing edge... Below shows the holes I am trying to fill. Can anyone help me? Thanks!
-Chris Z.