Cross-Section Conformity

[Rbrgr83]

So, I have a X-section view with a whole bunch of cut surfaces.
I want them all to display with the same hatch pattern (same angle, spacing, etc).


Can I tell all of them to follow the same patttern without having to define each one individualy? If so, how so?


if not --->

 

[Tobyk]

Don't think there's a way to "select all" and apply in one swoop.

But you could record a mapkey starting with a click on "next Xsec" and then apply spacing and angle values

Then it would be less of a chore going section by section.

TK

 

[Rbrgr83]

indeed


I was hoping to avoid the manual route, even if by mapkey.
But it appears to be the only way.


Thanks TobyK

 

[vlad1979]

I think this is what you need:


[url]http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=34 124&KW=default+spacing+vlad [/url]


In order for this to work you have to set those 2 parameters in all parts. And it will work only for newly created sections.

 

[Asho Pulsar]

I hav been fed up with d same problm, i got a huge sheetmetal assy, in dat only one cross section i need to represent in the drawing which intersects no. of parts. Asmentioned in that link works for givin values for spaces and angles. I need to delete the line which comes as double in one part n other part wont.


Is there any parameter for that to set single line to come.



Edited by: Asho Pulsar

 

[Asho Pulsar]

Where to give that two parameters other that relations menu. In that link parson mentioned setup menu. Its in the part modeling r drawing r view manager.


In part modeling edit-->setup-->no parameter option.