hfernandes29
New member
Hi ,
i have extruded a flat surface .On top of this surface I have extruded another
cylinder surface. However I just cant merge these 2 surfaces as the merge tab button just blank out.aAlso in case of the extend button as I create a datum surface to extend the created geometry , I just can't extend the created surface to the datum plene as the extend button blanks out. is it because I'm using wildfire 2 or should i make any changes in the config.pro file.
i have extruded a flat surface .On top of this surface I have extruded another
cylinder surface. However I just cant merge these 2 surfaces as the merge tab button just blank out.aAlso in case of the extend button as I create a datum surface to extend the created geometry , I just can't extend the created surface to the datum plene as the extend button blanks out. is it because I'm using wildfire 2 or should i make any changes in the config.pro file.