Posted: 09 April 2009 at 8:35am | IP Logged

2009-04-09_100846_exampl.prt.rar

I added some bending to your part. You can continue but will face some difficulity if you are not from Sheetmetal background.

Some BLOGS for quick and easy learning in Pro-E wildfire 2 Sheetmetal. I hope you can see from there.

Posted: 10 April 2009 at 12:47pm | IP Logged

2009-04-10_124206_module.prt.rar

 I think, it is a one issue drawback for Pro-E sheetmetal module.

Hopefully WF3&4 to solve the probem.

Your steps are still correct.

I used unbend and see bending line at V-shape.

Added Relief cuts and bend back.

Then addded another two bend to finalize.

Reference are in Model.

Posted: 11 April 2009 at 10:38am | IP Logged

2009-04-11_102417_QUESTION_2.rar

 Thanks you.....

For the first question, I just clear out relief cut from green two lines (fillet or stress zone). The bigger radius will cause bigger cut out. As long as relief cut clear enough, I think will be fine.But it is my unprofessional way.

For the second question, it asked you to make bend feature is left, right or center on the bending line that you defined. Attached PDF will show left, right and both will gave different lengths on bending.  

Best Regards,

Kratos.