Pro/ENGINEER Forum: Display Bend Directions

Active Topics

Help

Sheetmetal
Pro/ENGINEER Forum : Sheetmetal

Topic: Display Bend Directions

Author

Message

<< Prev Topic | Next Topic >>

hogpaw
Member
Member

Joined: 20 January 2009
Location: United States
Online Status: Offline
Posts: 1

Posted: 25 February 2009 at 3:21pm \| IP Logged

I am running WF 2.0 and trying to display the bend directions in my drawing when placing a flat pattern. Is there a way to do this?

CHINA
Member
Member

Joined: 21 March 2009
Location: United Kingdom
Online Status: Offline
Posts: 3

Posted: 21 March 2009 at 11:39pm \| IP Logged

the first: plat pattern

th last: bend

sorry!my english is very poor!

but i think to get friends whth you!

Kratos72
Member
Member

Joined: 09 April 2009
Location: Singapore
Online Status: Offline
Posts: 18

Posted: 12 April 2009 at 7:57am \| IP Logged

REFERENCE BLOG

Use SHOW/ERASE note in the View.

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

Printable version

Forum Jump

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

This page was generated in 0.2656 seconds.