Pro/ENGINEER Forum: SurfaceRegions in Mechanica

Active Topics

Help

Analysis
Pro/ENGINEER Forum : Analysis

Topic: SurfaceRegions in Mechanica

Author

Message

<< Prev Topic | Next Topic >>

ananthkotwal
Member
Member

Joined: 25 September 2008
Location: United States
Online Status: Offline
Posts: 3

Posted: 10 October 2008 at 4:59pm \| IP Logged

Hello all,

Do anyone explain how to create surface regions in pro/mechanica on the surface (one side) of a circular ring. (This surface should be in contact with the other part)

Thanks

stevetto
Member
Member

Joined: 29 September 2008
Location: Hong Kong
Online Status: Offline
Posts: 7

Posted: 20 October 2008 at 5:17am \| IP Logged

Contact analysis requires solid modell.

Make a sketch in Standard mode on the surface.
Switch to Mechanica.
Select the Surface region icon.
Select the sketch, you made earlier.
Select the surface of the model, where the region will be created.

You can also make the surface in mechanica on a similar way.

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

Printable version

Forum Jump

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

This page was generated in 0.2813 seconds.