Posted: 20 July 2008 at 12:04am | IP Logged

Hi dear friends,

The company that I'm working on, is now making the updgrade from wildfire 2.0 to wildfire 3.0, some of my CNC programmers told me, that they had been having problems with all the old post-processors made in wildfire 2.0, when they were trying to copy to the new wildfire 3.0 already installed.

Is any difference between these two g-post realeses?. How can these guys do to work with their old post-preocessors . Myabe the answer of this question is so simple to anyone of you, I apologized I'm not a CNC programmer, I'm a mechanical Engineer.

Thanks your all your advice

Best Regards

Pablo Ulloa