Posted: 13 March 2008 at 12:01pm | IP Logged

Good Afternoon

Has anyone used Wildfire 4.0 Sheetmetal. Im using the pre-production version. When I create a flat wall and try to attach a formed wall to the flat it asks me to select a an edge, I select an edge (In wildfire 2.0 the edge you select is an inside edge) In Wildfire 4.0 the default seems to be the outside edge (It doesn't ask you for an outside or inside edge or does it tell you toe select an outside edge). Im using a copy of my wildfire 2.0 config.pro in wildfire 4.0 so my config settings are the same. Is there a config setting used in wildfire 4.0 for default edge inside or outside that wildfire 2.0 doesn't need. Or is this a pre-production bug that was fixed in the released version.

Thank

Steve

Posted: 11 April 2008 at 8:57am | IP Logged

That was Pre-Production, have you tried the Production version?

The edge selection in WF4 has changed from WF2 and WF3 and this was intentional because of the issues that were seen with the Flip Wall functionality. So PTC has changed the edge selection and removed the Flip Wall from the default interface (can be added back with a CONFIG).

Try the production version.

Posted: 11 April 2008 at 9:51am | IP Logged

Extreme

Thanks. I'm loading the production version of Wildfire 4.0 in a few weeks.