I am looking for a basic training for a design engineer in Windchill.
Looked thru PTC videos and YouTube as well.
Did not find any solid info.
Iím having some issue with pro pipe and adding the bend data into a table in a drawing.
I used to do this with a previous employer but that was some time ago and I canít remember...
Is there a way to control view orientation with parameters?
I need to rotate a drawing view 90deg based on parameters associated with the model. Is this possible?
Wish I could say the same moldman, I went from Creo 2.0 back to Wildfire 5, UGH! :eek::eek:
When printing an assembly in Creo 3.0 (be it to PDF or to PostScript) the printout is coming out in Wire Frame, with all hidden lines displayed. I want to print with No Hidden, which is the way I...