BoM of Large Sub Assemblies

<big>
Hello everybody,



I have two assemblies A1 and A2.

Assy A1 contains sub assemblies SA1, SA2, SA3 and SA4

Assy A2 contains sub assemblies SA1, SA3, SA5 and SA6



This is what I need to do:

I need to create drawings for all the sub assemblies SA1,
SA2.......SA6, showing a BoM and balloons of all their components and
at the same time (on the same drawing) show how these sub assemblies
are assembled to the top assemblies A1 and A2.

I think the solution is in finding a way to add a "phantom" model of A1
or A2 in the drawings of the sub assemblies, without having that
"phantom" part show up in the BoM of the sub assembly (without having
to filter it out of the BoM table and without using shrinkwrap or
exported geometries). Does anybody know how to do this?



Regards</big>

You have to add assy A1 and A2 to the drawing of the sub assemblies (you can or not put some wiews of these assemmblies), then you can insert two different BOM, the first forthe assy A1 the second forthe assy A2. Finally you can configure the BOM of the two assy by attributes or filters as you need.