tjaudet829
New member
I am trying to simulate a suspension that has some rubber bushings in it.
The bushings need to act mostly like a pin but also have the ability to slightly
mis-align.
If I constrain using a ball joint it is a bit too free and the components roll and if I use a pin joint the assembly will bind up and not function properly.
Any advanced techniques or tricks that anyone can offer up?
Thanks,
Jeff
The bushings need to act mostly like a pin but also have the ability to slightly
mis-align.
If I constrain using a ball joint it is a bit too free and the components roll and if I use a pin joint the assembly will bind up and not function properly.
Any advanced techniques or tricks that anyone can offer up?
Thanks,
Jeff