Cam mechanism - eccentric cam and followe

Hi,

I need some tutorials on the mechanism setup for an eccentric cam and a shaft follower.

I'm using wildfire 2 but have problems with the depth display settings.

I only used cylinder connect constrain for the follower and the eccentric cam. Both of them are 90 degrees apart.

Any advise is appreciated. Thanks in advance.

There's a demo on this in the Pro/E Wildfire 2 installation:



<PROEWF2_loadpoint>\demos\demo\mdx\tutorial3\cam_fol lower.asm

bryanbryan010,


If you upload your parts or send the assembly to me ,I will make the mechanism for you.


Israr
Edited by: Israr