bryanbryan010
New member
Hi,
I need some tutorials on the mechanism setup for an eccentric cam and a shaft follower.
I'm using wildfire 2 but have problems with the depth display settings.
I only used cylinder connect constrain for the follower and the eccentric cam. Both of them are 90 degrees apart.
Any advise is appreciated. Thanks in advance.
I need some tutorials on the mechanism setup for an eccentric cam and a shaft follower.
I'm using wildfire 2 but have problems with the depth display settings.
I only used cylinder connect constrain for the follower and the eccentric cam. Both of them are 90 degrees apart.
Any advise is appreciated. Thanks in advance.