How do you insert an image into a drawing so it displays and prints
correctly? I'm using the Insert - Object - From File command in
Wildfire 2.0. Pro/E just displays and prints the filename in place of
the image.
There is a PTC express article about this at
http://www.imakenews.com/ptcexpress/e_article000369052.cfm ?x=b4vKK3r
but I can't make much sense of it. Any help would be appreciated.
Thanks,
Sam
correctly? I'm using the Insert - Object - From File command in
Wildfire 2.0. Pro/E just displays and prints the filename in place of
the image.
There is a PTC express article about this at
http://www.imakenews.com/ptcexpress/e_article000369052.cfm ?x=b4vKK3r
but I can't make much sense of it. Any help would be appreciated.
Thanks,
Sam