Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

data management

S_ACOSTA

New member
I am not sure if this is the place to post this topic.


I am trying to use this tip:
http://www.synthx.com/tom/sy_tip_0206.htm


But I get stuck because, the default parameter type is real, so if the parameter was not previously defined as a string (e.g. for a parameter like material or description) it does not work - it only allows numbers.


Is there any other way to get a similar result to the tip?


Basically I have a lot of legacy filesWITHOUT parameters like revision, part_number etc... and it would take too long to open every single one and define the parameters.
 

Sponsor

Articles From 3DCAD World

Back
Top