Hi champs,
I'm working in Mexico, and I'm a member of the local ProE users forums. There is a topic that is bringing us up side down. I hope some one here can help me (us). the problem is as follows:
I design in MM but 90% of my work must be prited out in IN dimensions. I have my own table for my BOMs. I want the 3 major dimensions to appear automaticly on my BOM on just one cell (dimX X dimY X dimZ) in Inches (remember that i use MM for my parts and assemblies) with 3 decimal places. I belive that I have to create a STRING, that reads and converts parameters in order to obtain what I want formated as shown above and 3 decimal places.
The problem is bigger when I create a part inside a assembly using datum planes and other datums as referencies and no dimensions are inputed.
Does anybody have solutions or tips for this.
I belive that this is possible. AFTER ALL EVERYTHING CAN BE DONE WHEN YOU USE PROE.
I'm using WF2.
Regards and thanks
I'm working in Mexico, and I'm a member of the local ProE users forums. There is a topic that is bringing us up side down. I hope some one here can help me (us). the problem is as follows:
I design in MM but 90% of my work must be prited out in IN dimensions. I have my own table for my BOMs. I want the 3 major dimensions to appear automaticly on my BOM on just one cell (dimX X dimY X dimZ) in Inches (remember that i use MM for my parts and assemblies) with 3 decimal places. I belive that I have to create a STRING, that reads and converts parameters in order to obtain what I want formated as shown above and 3 decimal places.
The problem is bigger when I create a part inside a assembly using datum planes and other datums as referencies and no dimensions are inputed.
Does anybody have solutions or tips for this.
I belive that this is possible. AFTER ALL EVERYTHING CAN BE DONE WHEN YOU USE PROE.
I'm using WF2.
Regards and thanks