Lets say you create a NC Sequence (eg. trajectory) to machine a square
boss that is modeled with all of its corners sharp. To save on
deburring time and make the part looks nicer, I'd like to drive
the cutter around the corners with say, small .005" or so radius.
Just wondering if there's a simple way (perhaps setting???) to "automatically" round up outside corners like that?
Please advise, thanks for looking
-mark
boss that is modeled with all of its corners sharp. To save on
deburring time and make the part looks nicer, I'd like to drive
the cutter around the corners with say, small .005" or so radius.
Just wondering if there's a simple way (perhaps setting???) to "automatically" round up outside corners like that?
Please advise, thanks for looking
-mark