vishnushankar
New member
Hi All,
I am facing a problem in Drawing program. I have posted the same message in the drawing forum too.
I have to control the view state using two parameters; for eg;
IF NO_OF_HOLES==3 & HOLE_LOCATION=="RIGHT"
SET STATE XYZ
ENDIF
the above doesnt work. Then I tried:
IF NO_OF_HOLES==3
IFHOLE_LOCATION=="RIGHT"
SET STATE XYZ
ENDIF
ENDIF
This too doesnt work...
There is a solution in which I could write a relation combining these two parameters and passing the value to a new parameter in the model and then using it in Drawing, but I dont want to do this....
Can anybody suggest a solution for this...
Regards
Vishnu
I am facing a problem in Drawing program. I have posted the same message in the drawing forum too.
I have to control the view state using two parameters; for eg;
IF NO_OF_HOLES==3 & HOLE_LOCATION=="RIGHT"
SET STATE XYZ
ENDIF
the above doesnt work. Then I tried:
IF NO_OF_HOLES==3
IFHOLE_LOCATION=="RIGHT"
SET STATE XYZ
ENDIF
ENDIF
This too doesnt work...
There is a solution in which I could write a relation combining these two parameters and passing the value to a new parameter in the model and then using it in Drawing, but I dont want to do this....
Can anybody suggest a solution for this...
Regards
Vishnu