how to unbend

I created a surface from boundaries and then i created unattached wall using offset option.Now if i try to unbend>regular and pick one of the edge as fixed geom it says Inappropriate geometry.


I tried another method using deformation area but it did not work.


see attached file2005-04-19_152634_bend.prt.zip


any idea?


thnks in advance

hi,


i think this will help you out......if any further doubt you can mail me on [email protected]





Regards,


Prashant


2005-12-21_010502_bend.zip

ra_inder,


you can use flatten quilt command for this very simply problem.


Israr

hi israr,


i already tried it and it give failure........why don't you try and upload the part so that we can also review how it can be possible.


Thanks


Prashant

OK, Here is the solution using flatten quilt.


2005-12-22_075358_bend.prt.zip