Hello everyone,
I'm trying to create an animation of a surgical retraction system however, I'm running into some problems. ProE keeps crashing out on me. I have over 50 different connections created in the various assemblies and sub-assemblies. After a couple of corrupted workspaces and a couple different assembly model methods I have the assembly to a point where the model doesn't automaticly crash out on me. Once I go into Animation I'm able to string my Key Frame Sequences together but on about number 3 or 4 it will always crash on me. I'm not sure if I've reached a software limit or a hardware limit.
Is there a "limit" on the number of connections that you shouldn't go over? Or am I just reaching my 1GB of ram's limit?
I'm running WF1 2003250, 1GB RAM, Quadro4 980 XGL
Thanks Everyone,
Justin
I'm trying to create an animation of a surgical retraction system however, I'm running into some problems. ProE keeps crashing out on me. I have over 50 different connections created in the various assemblies and sub-assemblies. After a couple of corrupted workspaces and a couple different assembly model methods I have the assembly to a point where the model doesn't automaticly crash out on me. Once I go into Animation I'm able to string my Key Frame Sequences together but on about number 3 or 4 it will always crash on me. I'm not sure if I've reached a software limit or a hardware limit.
Is there a "limit" on the number of connections that you shouldn't go over? Or am I just reaching my 1GB of ram's limit?
I'm running WF1 2003250, 1GB RAM, Quadro4 980 XGL
Thanks Everyone,
Justin