Sheet metal cut from scanned image?

I'ma newbie here, so forgive me if this has been asked before.


I have a company logo that I'd like to cut into sheet metal. I can scan this, but is it possible to import a picture and sketch over it? I don't have a digitizer, and other than tracing this to graph paper and using points, I don't know how to go about this.


Any help appreciated.


regards,


Sean

Take a look at this thread - it involves the same thing.


[url]http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=26 551&PN=1[/url]