Process Plan

Dear Collegues


My name is Young-Ki Chang, and I am student at University of Florida. I have question about report drawing.


When generating the report drawing for a process plan, is it possible to insert a range of steps into tables? (rather than creating repeate regions & inserting the steps all or one-by-one)


Thank you very much


You can contact me at [email protected]





Sincerely





Young-Ki Chang

Young-Ki Chang


Onewayto produce all the steps into one page or table is to create the table in a drawing format.


If the format carries the table with say 2 columns i.e.


Step number Description
&prs.step.number &prs.step.desc


All the process steps will be shown once the drawing sheet is formatted.


Remember a drawing format can have 2 sheets to it.
So you can select say format sheet 1 with the table above for the firstsheet of the drawing, and format sheet 2 with drawing views part numbers etc on the subsiquentdrawing sheets


Aaron Chapman

hi



can any one tell me about,process plan for assemblies?



watz the use of it



regards

leenus

from a assembly, its like a exploded view which shows lines from part to part showing how it should be constructed.

Heh yall


Any body got any good tutorials?


cheers