Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Register Log in

G43

T

the_real_jat

New member
wasup


i have a G43 H01 Z -1.0 X1. Y1.2 R .05 F 20 .. i guess not sure about the XYRF paramenters here.. but is there any way in the FIL, i can split this statement into two. The first being G43H01Z-1.0 and the rest in next line.


~JAT
 
the_real_jat said:
wasup


i have
a G43 H01 Z -1.0 X1. Y1.2 R .05 F 20 .. i guess not sure about the XYRF
paramenters here.. but is there any way in the FIL, i can split
this statement into two. The first being G43H01Z-1.0 and the rest
in next line.


~JAT
Click to expand...



I suppose that this movement is RAPID and you use GPost? If so, try to set this :

Motion--> Rapid-->Motion Analysis-->XY rotary then Z



I hope it helps

-mark
 
the_real_jat said:
thanks mark



that helped to some
extent.
Click to expand...



Oh... what's left then?

smiley1.gif




-mark
 
Try putting a positive value in the post processor tool change coordinate for theZ axis.And also that inyour worcell theCL output option "FROM" is set to only at start.
 
You must log in or register to reply here.

Sponsor

Articles From 3DCAD World

Back
Top