Hiall,
ProE always seemed to me being very "click-intensive". For instance
assigning lead-in and -out to a simple trajectory toolpath takes like
million clicks and it's always the same, because you want climb
milling, left offset, and all that. It ticks me off, I was NC'ing some
flanges today and every bleeding hole needed to be chamfered, made Mr.
Karpal happy.
Hence I wonder if there's any way to improve that? I suppose some kind
of hotkey could help, but that's a half-a*s solution. Anyone?
ProE always seemed to me being very "click-intensive". For instance
assigning lead-in and -out to a simple trajectory toolpath takes like
million clicks and it's always the same, because you want climb
milling, left offset, and all that. It ticks me off, I was NC'ing some
flanges today and every bleeding hole needed to be chamfered, made Mr.
Karpal happy.
Hence I wonder if there's any way to improve that? I suppose some kind
of hotkey could help, but that's a half-a*s solution. Anyone?