We are using Wildfire and constantly have problems machining flat bottomed pockets, normally I use a volume sequence with a window set to roughing then followed by a volume sequence with the same windowset to profile and then followed by a Faces only sequence set to spirol again using the same window. 50% of the time Faces only causeswildfire to bomb out (commonly Known as the quick exit feature).
Does any body know any work arounds? or other stratagies i coulduse.
We are using Cut 2003490 if this helps
Does any body know any work arounds? or other stratagies i coulduse.
We are using Cut 2003490 if this helps