Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Intralink initial import scheme

tham

New member
We are implementing Intralink after using Pro-E for a few years. By "using Pro-E" I meant abusing Pro-E. We now have many assemblies with missing parts and some with circular references troubles. To make matters worse, many are very large assemblies.


My plan of action has been to import in the following order: (1) parts (2) assemblies (3) drawings


smiley25.gif
My question is: Has anyone gone through a messy implementation and do you have any suggestions on a good scheme for resolving these? Do you have a trick to get around these ghost objects created by parts that are simply gone?


Our numbers are approximately as follows:


Parts: 6,700


Assemblies: 2,200


Drawings: 1,000


Any suggestions would be helpful.


Thanks in advance
 
You should havestarted using Intralink some 5,000 parts ago. Intralink will not fix "missing files". I would not import bad assemblies in Intralink, you'll end up with a bunch of ghost objects. You need to bite the bullet andfix them first.


Good Luck
 

Sponsor

Articles From 3DCAD World

Back
Top