rjmcgill60
New member
Version: 2000i2
Manf Code: 20001310
Config ID: 13496
This has probably already been addresed but I can't find anything on it.
I've noticed that when my assembly model is oriented in certain non-orthogonal positions, some of the object lines of a component drop out. The same thing happens in drawing views.
I just started working with 2000 i2 again but also noticed this problem with 2001. Usually I can re-orient the model or view until the lines show up but I'd like to fix this if possible.
Is this a bug? Is there a better fix?
Manf Code: 20001310
Config ID: 13496
This has probably already been addresed but I can't find anything on it.
I've noticed that when my assembly model is oriented in certain non-orthogonal positions, some of the object lines of a component drop out. The same thing happens in drawing views.
I just started working with 2000 i2 again but also noticed this problem with 2001. Usually I can re-orient the model or view until the lines show up but I'd like to fix this if possible.
Is this a bug? Is there a better fix?