while we analyzing a body which are consist of some 3D profile, we either can use some of different meshing size definition, then so called as local mesh size.
The objective is to find a good stress distribution at critical area which is being analyzed. Try to set a different size at a certain critical area, we either use a its variation meshing size. that's so called as convergence study.
If somebody want to get it more detail, you can email me at the following address:
[email protected]
The objective is to find a good stress distribution at critical area which is being analyzed. Try to set a different size at a certain critical area, we either use a its variation meshing size. that's so called as convergence study.
If somebody want to get it more detail, you can email me at the following address:
[email protected]