maximum draft angle in Wildfire

I noticed in the 2001 release that the maximum draft angle was bumped up from 3 degrees to 30 degrees - Does anyone know the maximum angle in WildFire?

It just happens that I'm doing one right now and the range is up to 30

Not that this answers you question, but it was not 3

Wazzup, G??!! (sorry, I couldn't help it)



I was told that it was 3 degrees - I'd better question my sources, source again Then again, maybe I misunderstood!



I agree - why in the world would you need a 30 degree draft angle? In order to pull a mold, without it peeling normally only requires a 2-3 degree angle.



I haven't done that many molds, so maybe a 30 degree is used a lot in other industries besides mine.



I guess if you're modeling a cup you might jump up to 10 degrees? But that's out of my world of experience...