Would like to be able to route my first point out of the connector using an
Offset with
zero- Left_Right,
zero- Up_Down and
0.5 -straight out
and have all segments be the same length.
to my frustration, after routing one location of the flat cable, it already has a twist. due to routing constraints, am trying to keep flat cable parallel routed in between 2 PCBs
Jh
Offset with
zero- Left_Right,
zero- Up_Down and
0.5 -straight out
and have all segments be the same length.
to my frustration, after routing one location of the flat cable, it already has a twist. due to routing constraints, am trying to keep flat cable parallel routed in between 2 PCBs
Jh